Bicycles and Parts

Bike Brake Tips

Gadgets: it takes ten minutes to adjust the brakes on a race. The result get a better feel of the brake lever, the more power and less noise. Here’s how!

It is easy to set the brakes, though encounters often on bicycles with poorly adjusted brakes. It feels slow to slow, it is most likely the cable and housing that must be replaced or lubricated. Feel the brakes spongy, it is most likely that the brakes must be set up better. For a distinctive, effective and easily controllable braking requires that it is set correctly and that the wires are in good condition.

It is important that the brakes are far enough from the rim for not scrape against it, as well as to both the bricks come into contact with the rim at the same time when you brake. Remember that there should be special brake pads to kolfiberfälgar. Use wheels with rims and braking surface of carbon fiber, it is especially important to set brakes carefully. This is because the brake shoes is often less effective than they do against aluminium wheels.

  1. Start by checking that the bricks are fresh.Sometimes sticks the aluminum pieces and other things in the brake rubber.It degrades the braking force and wears more on the rim. Clear the bricks with a knife or a fine screwdriver. Beware your fingers!
  2. Adjust the brake roughly with the help of centrumbulten, the one who keeps the brake in place on the frame that is.To brake is located equidistant from the rim when the brake is not activated, is not as important as the wheel during braking touches at the same time. When you grovjusterar with centrumbulten, it is enough to look at the distance between the rim and the brake.
  3. Now it’s time for finesse.Using the small adjustment screw which usually sits on the left side or top controls the man bromsklossarnas centering relative to the rim.Provbromsa and check that both bricks takes the wheel at the same time and that no block press the wheel sideways when you brake with full force.

The brake must be set so that the entire brake pad against the braking surface, both in height and angle. Ports brake pad for high up, near the bicycle tire light can quickly tear holes in the deck side. Sit low down, bricks get poorer braking function. Loosen the screw bromsklossens, slowing down slightly and adjust the block with your hand so that it lies completely flat against the rim braking surface. Tighten the screw before you release the brake.

If you have problems with noise when braking, it’s probably because its setting against the rim, or to rim or block is dirty. Start by cleaning the rim properly and maybe roughen up brake pad with a file or Emery cloth.

Remains sound so make sure that the block is completely against the rim braking surface.It is also better to the front of the brick goes in before the rear when braking. It goes back to the first effect worse and brake can howl.

Leave a Reply